Ceiling Breach Machine

• The main frame will be fitted with four swivel wheeled jacks with fold away handles for easy movement.
• The frame will rest on rubber machinery mounts when in use.
• There will be two movable areas, the ceiling-pull device and the hinged door; Each will be weighted with tamper proof weights.
• The movable items will have replaceable neoprene bumpers to act as stops.
• Painted with primer and enamel

Note:

• With the addition of the Neoprene Bumpers and the Rubber Machinery Mounts the noise level is greatly decreased.

---

Equipment Carry

• 17" wide x 5' - 7" long x 5' - 10" tall
• All panels welded in place
• Opening approximately 19-3/4" x 64-3/4"
• Painted with primer and enamel

Vest Cart

• Cart will be 48" x 60" and approximately 70" tall
• Steel construction with 16 stainless steel hangers and 4 stainless steel trays
• The cart capacity is 16 vests
• 2 swivel casters with a brake and 2 rigid casters
• The steel portion will be painted with primer and enamel

---

Forcible Entry Support Frame

• Built to fit forcible entry unit
• Painted with primer and enamel
• Holes in the base for fastening to the floor

---

10 Pound Sledge Hammer Sled (Picture not available)
Similar to the existing type with the following additions.

• A support tube was added in the center of the frame to support the slide tray when walked upon.
• Four tabs were added to each side of the outside of the SS Slide Tray and bolted to the frame to maintain the flatness of the tray
• The steel portion will be painted